centreerringen

Barry_C70 · 17-05-2010 18:16:07

How tight should a centreerring fit on the center hub? I just removed one of the rims and the apparent 65,1mm centreerring does fit on the hub ok but I can wobble it about by about 1mm IF that, so it's not as snugly fit as I think it should be.

is the center hub of a C70 the same as a S/V70? 65,1mm?

Barry_C70 · 17-05-2010 21:44:45

just checked one of the rings again, the markings on the rings are correct (73.0 65.1) but the ring doesn't fit very snugly on the hub. Will probably look into finding a new set

C70 hub is 65.1 right?

Ludo · 17-05-2010 21:48:18

Citaat van: Barry_C70 op 17-05-2010 21:44:45
C70 hub is 65.1 right?

Ja, 850, S/V/C70 is allemaal hetzelfde.

Barry_C70 · 17-05-2010 21:59:00

so why does a 65.1 ring not fit snug on my hub? crap ring?

Ludo · 17-05-2010 22:16:24

Daar kijkt het dan wel op.

Maar als het naafgat 65,1mm is, waarom heb je dan een centreerring nodig?.
Of mis ik iets?.

BenC70ES · 17-05-2010 22:25:27

Citaat van: Barry_C70 op 17-05-2010 21:44:45
just checked one of the rings again, the markings on the rings are correct (73.0 65.1)

Dit Ludo?

Ludo · 17-05-2010 22:37:26

Ik mis het nog steeds Ben.

mehn · 18-05-2010 06:35:18

Citaat van: Ludo op 17-05-2010 22:37:26
Ik mis het nog steeds Ben.

Velggat is waarschijnlijk 73

Barry_C70 · 18-05-2010 12:35:16

ordered new rings from a different guy and will try them on later today

-D©©©L- · 18-05-2010 17:29:26

Citaat van: Barry_C70 op 18-05-2010 12:35:16
ordered new rings from a different guy and will try them on later today

Plastic ?

UserID6342 · 18-05-2010 17:59:10

Citaat van: -D©©©L- op 18-05-2010 17:29:26
Citaat van: Barry_C70 op 18-05-2010 12:35:16
ordered new rings from a different guy and will try them on later today

Plastic ?

= same problems

pwassink · 18-05-2010 20:01:05

Citaat van: Dirk342 op 18-05-2010 17:59:10
Citaat van: -D©©©L- op 18-05-2010 17:29:26
Citaat van: Barry_C70 op 18-05-2010 12:35:16
ordered new rings from a different guy and will try them on later today

Plastic ?
= same problems

Sommige zijn gewoon niet te redden zonder veel bovennatuurlijke machten aan te roepen ..

UserID6342 · 18-05-2010 21:03:07

Citaat van: pwassink op 18-05-2010 20:01:05
Citaat van: Dirk342 op 18-05-2010 17:59:10
Citaat van: -D©©©L- op 18-05-2010 17:29:26
Citaat van: Barry_C70 op 18-05-2010 12:35:16
ordered new rings from a different guy and will try them on later today

Plastic ?
= same problems

Sommige zijn gewoon niet te redden zonder veel bovennatuurlijke machten aan te roepen ..

+ 1

Barry_C70 · 18-05-2010 21:48:34

okay, so ignoring the smart asses...

had an intelligent discussion today with a guy who suggested getting hub centric ring SPRINGS! Because the rings which are probably the correct diameter, are popping out of the rims and then sliding to the back of the hub where the diameter is slightly smaller than 65,1mm.

Ordered new 65,1mm and 64,1mm rings (because they ordered 66,1mm, dumbasses) will see what fits better, will inquire about the springs too.

-D©©©L- · 18-05-2010 21:55:46

Veerringen ? da's wel heel creatief !